Wall Mounted Single Toilet Roll Paper Holder - CDCR Compliant
The AA-TP1-CDCR Stainless Single Roll Toilet Paper Holder that is California Department of Corrections and Rehabilitation (CDCR) compliant. Designed as a simple holder to be surface mounted, the toilet roll is placed in the "cup" of the bracket.
Public Restroom Facility Designed For:
The AA-TP1-CDCR Stainless Single Roll Toilet Paper Holder is suitable for all public restroom facilities where compactness is important and high use or corrosion is a concern.
The AA-TP1-CDCR Stainless Single Roll Toilet Paper Holder is available in 12 gauge Stainless Steel for California Department of Corrections and Rehabilitation (CDCR) facilities.
This toilet paper dispenser is available in 304L Stainless Steel. For most restroom facilities, 304L is the most cost effective solution as it it provides good corrosion resistance in non-salt water environments.
Toilet Paper Capacity:
The AA-TP1-CDCR Stainless Single Roll Toilet Paper Holder holds a single 5" toilet paper roll.
The AA-TP1-CDCR Stainless Single Roll Toilet Paper Holder is ADA compliant when properly mounted and installed.
The AA-TP1-CDCR Stainless Single Roll Toilet Paper Holder is intended to be securely mounted using at a minimum 3/8” lag bolts. It can be partition mounted, or securely anchored into cinder block using 3/8” lag bolts that fully penetrate the cinder block. For sheet-rock installations it is necessary to use a 3/4” backing behind the sheet-rock to ensure it is securely fastened to the wall.
- Heavy Duty Commercial Design
- Made in USA
- Surface Mounted
- CDCR Compliant
- Corrosion Resistant
- Industry Leading Warranty against Vandalism
- Width: 6”
- Height: 6”
- Depth: 4”
- 12-gauge 304L Stainless Steel
- Stainless Steel Satin # 4 Finish
- 3/8" Mounting Hole Placements
- 1 Standard Core 5" Roll
- 1 High Density 5" Coreless Roll
Secure fixture to wall with appropriate 3⁄8” Stainless Steel anchoring hardware for optimal installation strength (not provided). Recommend 3⁄4” or greater back bracing for walls. Partitions may require T-nuts or other suitable anchoring devices. When possible it is recommended that units be through bolted back-to-back providing optimal installation strength.
Dispenser shall be constructed with American made, 12 gauge 304L or 12 gauge 316L Stainless Steel joined /w full seam TIG welding and edges de-burred. Dispenser shall not be cross-metal contaminated during manufacturing construction. Dispenser shall have 3⁄8” mounting holes.
Surface Mount Dispenser Shall Be:
- Model # AA-TP1-CDCR-304L-12g
No customer reviews for the moment.
- Height 6
- Width 6
- Depth 4
I work as a contractor for a high profile client in the south. We had an issue with the public taking JRT rolls to the tune of...