Hardware Mounting Kit
- Ensure your Vandal Stop Products are securely mounted to the wall using our 3/8" Diameter X 3" Long Stainless Steel Lag Screws mounting kit.
- Meets requirements for warranty coverage of your Vandal Stop Products against vandalism.
- Each mounting kit includes 4 stainless steel screws with washers and is sufficient to secure one product to the wall.
- Soap dispensers require just two screws so this hardware kit will is enough to secure two soap dispensers.
Note.... Warranty Coverage against vandalism requires that you use 3/8" mounting hardware. You DO NOT need to purchase the mounting hardware from us for warranty coverage as long as you use the correct 3/8" hardware appropriate for your situation. We only offer mounting hardware as a convenience to our customers that have need for it.
Mounting Hardware:
Our customers face a variety of installation scenarios be that wood, concrete, cinder block, sheetrock or metal partitions. Because of the variety of installation scenarios possible, it is not cost effective to provide the correct mounting hardware for each instance with our products. You may purchase your appropriate mounting hardware from us as an add-on product or source it from your own hardware supply store.
Customers:
For full warranty protection, it is imperative that you ensure your installer uses the specified ⅜” diameter mounting hardware. Failure to do so may limit your warranty coverage against vandalism.
Theft Concerns:
If theft of the unit is a concern then it is highly recommended that you use appropriate anti-theft devices such as Loc-Tite thread compound or security head type screws. Back to back through bolting on metal partitions is also highly recommended.
Warranty Against Theft:
If you would like to extend your product warranty to cover your installation and protect against possible theft then you may purchase our Vandal Stop Theft Proof security mounting hardware kits along with your product. These kits come with screws that contain a special registered head pattern that can only be turned with our special registered bit head.
Installers:
It is imperative that you install our products with ⅜” diameter mounting hardware that is applicable for your situation. Failure to do so could void the warranty of the products against vandalism.
Standard sheetrock screws are NOT sufficient mounting hardware for the product to be completely secure and warranted against vandalism attacks..